• Sven Eckelmann's avatar
    ath79: Add support for OpenMesh MR900 v2 · 31172e53
    Sven Eckelmann 创作于
    Device specifications:
    * Qualcomm/Atheros QCA9558 ver 1 rev 0
    * 720/600/240 MHz (CPU/DDR/AHB)
    * 128 MB of RAM
    * 16 MB of SPI NOR flash
      - 2x 7 MB available; but one of the 7 MB regions is the recovery image
    * 3T3R 2.4 GHz Wi-Fi
    * 3T3R 5 GHz Wi-Fi
    * 6x GPIO-LEDs (2x wifi, 2x status, 1x lan, 1x power)
    * 1x GPIO-button (reset)
    * external h/w watchdog (enabled by default))
    * TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
    * 1x ethernet
      - AR8035 ethernet PHY (RGMII)
      - 10/100/1000 Mbps Ethernet
      - 802.3af POE
      - used as LAN interface
    * 12-24V 1A DC
    * internal antennas
    Flashing instructions:
    Various methods can be used to install the actual image on the flash.
    Two easy ones are:
    The tool ap51-flash (https://github.com/ap51-flash/ap51-flash
    ) should be
    used to transfer the image to the u-boot when the device boots up.
    initramfs from TFTP
    The serial console must be used to access the u-boot shell during bootup.
    It can then be used to first boot up the initramfs image from a TFTP server
    (here with the IP
       setenv serverip
       setenv ipaddr
       tftpboot 0c00000 <filename-of-initramfs-kernel>.bin && bootm $fileaddr
    The actual sysupgrade image can then be transferred (on the LAN port) to the
    device via
      scp <filename-of-squashfs-sysupgrade>.bin root@
    On the device, the sysupgrade must then be started using
      sysupgrade -n /tmp/<filename-of-squashfs-sysupgrade>.bin
    Signed-off-by: default avatarSven Eckelmann <sven@narfation.org>
    [rebase, add LED migration]
    Signed-off-by: default avatarAdrian Schmutzler <freifunk@adrianschmutzler.de>